Page Comparison

1.

Gateway-Configuration

Load the device credentials DEVEUI, APPEUI (JOINEUI) and APPKEY supplied with the MLRTPS into your gateway.
Questions about device credentials can be sent directly to devicecredentials@micropelt.com.

2.

Installation

The MLRTPS is delivered with the battery disconnected. Mount the base plate on the wall, connect the battery of the MLRTPS and clip the housing onto the base plate.

3.

Activation and operation

When the battery is first connected, the MLRTPS will immediately activate and send a Join Request to the gateway.

1. First acoustic signal (and 1x LED): confirms successful activation.

2. Double acoustic signal (and 2x LED): confirms successful join to the gateway.

Normal operation: For the first 5 minutes after activation the device will communicate every 10 seconds. Thereafter the device communicates in a fixed radio communication interval (5 minutes).

Failure: Long acoustic signals indicate failed operations.
Remark join failure: Gateway or device credentials not configured Multitech MTCAP Gateway.
Repeat the process with step 4. RESET

4.

RESET

To perform the RESET, press any one of the push-button as shown in the picture (tone signal and 1x LED). The MLRTPS restarts and attempts to join the gateway.

Image Removed

Image Added

Additional things to know

• LoRaWAN 868MHz CLASS A

• Ambient Temperature sensor (± 0,5°C)

• Passive Infrared Sensor - Detection Range approx. 8m

• Set Point Values (-4° to +5° and Frost Protection)

• Battery - Primary Cell 3.6V (2600mAh)

Tel: +49 (0)7665 93 21 83-0
E-Mail: info@micropelt.com
https://micropelt.atlassian.net/wiki/spaces/MH