Copyright Micropelt

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 31 Next »


FPort Number

Type of operation

Payload length

Description

Comments

0x00

MAC Commands

8 Bytes

RESERVED


0x01

  • Valve position % mode

  • Temperature setpoint mode (°C) with ambient or external temperature sensor

Downlink:
6 Bytes

Uplink:
11 Bytes

  • Actuator operation mode with valve position %

  • Self-regulation mode using the requested ambient setpoint temperature




Strongly recommended to always use an external temperature sensor

0x02

Report:

  • REV

  • Hardware Version

  • Firmware Version

Downlink:
0 Bytes

Uplink:
6 Bytes

Request:

  • REV

  • Hardware Version

  • Firmware Version


0x03 

 Motor Travel Distance

Downlink:
1 Byte

Uplink:
1 Byte

Configure motor travel distance (mm)


0x04 

 Data Rate

Downlink:
1 Byte

Uplink:
1 Byte

Configure LoRa data rate

Only supported in the MLR003R/ Radiator product line.

MLR003F/ Domestic Hot Water product line is using ADR.

0x05

Slow Harvesting (SH) and valve Opening Point Detection (OPD)

Downlink:
1 Byte

Uplink:
1 Byte

  • Activate, configure, and deactivate OPD and SH

  • View status of OPD and SH

Only supported in the MLR003R/ Radiator product line.


0x06

Temperature Drop Detection (TDD)

Downlink:
1 Byte

Uplink:
1 Byte

Configure response to Detection of a Temperature Drop

Only supported in the MLR003R/ Radiator product line.

0x07

PID Temperature Control

Downlink:
6 Bytes

Uplink:
6 Bytes

Configure the PID-Coefficients

Only supported in the MLR003R/ Radiator product line.


0x08

Temperature Estimation Algorithm

Downlink:
1 Byte

Uplink:
1 Byte

Configure the Temperature Estimation Algorithm Coefficients

Only supported in the MLR003R/ Radiator product line.

0x09

External Temperature Sensor Expiry

Downlink:
1 Byte

Uplink:
2 Bytes

Configure the External Temperature Sensor Expiry Time

View Temperature Source currently in use

Only supported in the MLR003R/ Radiator product line.

0x0a

External Temperature

Downlink:
1 Byte

Uplink:
None

Send the Room Temperature from an external temperature sensor to the device

Only supported in the MLR003R/ Radiator product line.

0x0b

Beep

Downlink:
1 Byte

Uplink:
None

Instruct the device to beep

0x0F

On/Off

Downlink:
1 Byte

Uplink:
1 Byte

  • Instruct Device to stay ON even if 6-week Reference Run finds that device is Unmounted

  • Instruct a Recalibration

  • Instruct a device to switch OFF


  • No labels