| Installation cycle | Standard operation | Idle state | Radio failure | Forced heating | Freeze Protection | ||||||||
Comments |
| Valve target % Or Flow target temperature
| Phases between monitoring and communicating | Uplinks not received by the gateway | Valve opens to 50% (or remains in current position if current position is
| Valve opens to 95% (or remains in current position if current position is
| ||||||||
Trigger | Magnetic switch. Join accept from Gateway, & Device is mounted | Internal timer | Internal timer | From activation: No Gateway connect From standard operation: 3 consecutive Gateway communication failures | Battery voltage < 2.2V | Flow sensor raw temperature
| ||||||||
Radio communication interval (RCI) | 10 seconds for 5 minutes |
15 minutes 60 minutes 120 minutes 480 minutes | OFF |
Three times 30 seconds
Then once 2 minutes60 minutes | OFF | OFF | ||||||||
Dynamic change of communication interval
| No | Yes | No | No | No | No | ||||
Sensors (flow, ambient) | Active, every 10 seconds | Active | OFF
| Active | OFF | Active, every 2 minutes | ||||
Freeze protection | Active, every 10 seconds | Active, every 150 seconds | OFF | Active, every 150 seconds | OFF | Active | ||||
Motor operation | Reference run. Then active, every 10 seconds | Active, according to Radio Communication | OFF | Active | OFF | OFF | ||||
Monitoring of battery | Active, every 10 seconds | Active | OFF | Active | Active, every 12 hours | Active, every 2 minutes | ||||
Internal temperature controller | If User Mode is |
Setpoint Flow Temperature: active | If User Mode is |
Setpoint Flow Temperature: active | OFF | If Safety Mode is |
Setpoint Flow Temperature: active | OFF | OFF |
Default upon activation and no downlinks | Setpoint |
Flow Temperature 55°C |
Flow offset +5°C
Setpoint flow 55°C
Flow offset +5°CSetpoint Flow Temperature 55°C RCI 60 minutes | Setpoint |
Flow Temperature 55°C |
...
| Orah footnotes display |
|---|