Page Comparison

...

...

• an RFID reader should be connected

Process

1. Open the Updater Tool

2. The Updater Tool will create a new CSV file to store the credentials of the updated devices

3. For each device:

   1. WARNING: Keep each device paired with its original cover

   2. Carefully remove the cover from the device

   3. Place the cover on the RFID reader

   4. Plug the USB into the device

   5. WARNING: While the Updater Tool is attempting to flash the device, do not unplug the USB

   6. On the Updater Tool, click “Flash”

   7. Press and hold the button until the tool reports that it has detected the device (the tool will detect the device a couple of seconds after the device beeps; note that the tool may report detection to the console window but not to the application window)

   8. Release the button and wait

   9. The Updater Tool will report successful or unsuccessful flashing of the device

   10. Upon successful flashing, the Updater Tool will log the device credentials to the generated CSV file

   11. Upon flashing completion (success or failure), unplug the USB, reattach the antenna to the back cover, and carefully replace the cover

4. Close the Updater Tool by clicking the red 'X' in the top right corner. The Updater Tool will email Micropelt with a list of updated devices, so that Micropelt can keep their stock list up-to-date. The Updater Tool will report if the email fails to send; in such a situation, please manually email Micropelt with the generated CSV file.

Photos of opening a device

...

A RFID reader should be connected	ACS ACR1252U preferred with appropriate drivers https://www.identible.de/acs-acr1252u-usb-nfc-reader.html https://www.acs.com.hk/en/driver/342/acr1252u-usb-nfc-reader-iii-nfc-forum-certified-reader/
Opening the device	Image AddedImage Added
Notes	The Firmware Updater Tool retains the original Application Key for each device. Thus, if the device will continue communicating with the same Gateway, then there is no need to update the device credentials within the Gateway.
Problems and Possible Solutions	If flashing fails, try plugging the USB into a powered USB hub If flashing fails, try a different USB cable
Process	SEE Flowchart below
Gliffy imageAttachmentId att38797313 macroId 721852cf-cebd-4011-ac37-5f71da8b77b5 baseUrl https://micropelt.atlassian.net/wiki name Updater Tool diagramAttachmentId att38633512 containerId 35749889 timestamp 1705322970053