Wattsense Gateway Setup and Instructions

Login into the Wattsense console via the following address https://console.wattsense.com/login?redirect=/boxes-map

1. If you don't have a login, please contact Wattsense Customer Support

To add a new device, open the Configuration Wizard by navigating to the following

1. Boxes → Configuration → Equipment → Add Equipment → Configuration Wizard

Choose Select Equipment

Choose micropelt - mlr_003 under equipment name

Choose LORAWAN_V1_0 as the version

Enter the Equipment Name, DEVEUI, APPEUI and APPKEY of the device and click Next

Select all the properties that needs to be decoded and displayed. (It is recommended to select all the properties)

Click Save Changes and click Send to Box to add the device to the Gateway

Mount the device on the valve and activate it by holding the magnet on the “micropelt“ logo for 1 second

The device will join the gateway and do a reference run (indicated by beeps and LED)

1. Beep-Beep (2x RED LED) → Successfully Joined to Gateway

2. Beep-Beep-Beep (§x RED LED) → Successfully finished Motor Reference Run

3. Long Beep (Failed to Join to Gateway / Failed Motor Reference Run)

Once the above step is completed, the decoded messages can be viewed in the Live Data Tab

Raw Payload and Encoded Downlink Message options are also available in the Live Data Tab

Use excel decoder tool to prepare the 6 byte downlink message

1. MLR003 Payload Encoder/Decoder

Paste the hex data into the encoded downlink message property in the format

1. <hex_message>:<port>

Click Save

The device will receive the downlink in the next radio message cycle